In the long-term use of single-sided vertical balancing machine, if the operation is slightly negligent, it will cause some measurement value error, then how to correct it? Don't worry, first of all, we need to determine the reasons for the instability of the single-sided vertical balancing machine, including the following five aspects:

1) The rotor shaft bends or the circumference beats, and the finish is extremely poor. A rotating body supported by a bearing, such as a disk-shaped workpiece, does not have its own rotating shaft.
2) Roller bearing ball wear or roller outer circle finishing, the round beat is too bad.
3) The axial force of the axial stop is too large.
4) The vibration sensor transmission rod is loose or the vibration is blocked.
5) The cable plug or socket of the vibration sensor is loose, causing signal blocking (the resistance of the sensor is about 4K, and the input impedance of the electrical measuring box is 70K).

Through the reasons for the instability of the above five measurements, we can make corresponding corrections based on these reasons, "correct drugs" to stabilize the dynamic balance of the measured values.

In fact, there are many factors that cause the balancer to not work properly or to achieve balance accuracy. Some of these factors are the cause of the workpiece balance and some of the reasons for the machine itself or the electrical measurement system. Therefore, as long as a certain link is not normal, it will inevitably affect the balance of the workpiece. If we can analyze these phenomena in a targeted manner, we can help us to correctly distinguish and determine the causes of various situations, and then take effective measures to reduce or eliminate these phenomena. The effect of unfavorable factors on the balance of the workpiece.

After explaining how to stabilize the measurement of a single-sided vertical balancing machine, let's take a look at it.

The single-sided vertical balancing machine is a balancing machine with a wide range of applications. It is suitable for calibrating single-sided balances in the vertical state of disc-shaped workpieces, such as fans, blades, impellers, brakes, clutches, pulleys, etc. The disc members are balanced for correction.

Guangzhou Zhuo Xuanjin engineer reminds: Balance machine is a high-precision measuring instrument after all, maintenance personnel require certain electrical knowledge, especially weak electricity knowledge, so choose the approved professional maintenance as much as possible, Guangzhou Zhuo Xuan Jin balance machine after-sales service consulting :020-36969823.