The amount of imbalance that occurs during the daily production of a rotating object is the main cause of product failure. Therefore, it needs to be corrected by a dynamic balancing machine, but in fact, we do not understand the dynamic balancing machine. There are many influencing factors when measuring the balance machine. The following small series will be introduced to you.
1. The transmission belt does not meet the requirements and there are obvious seams.
2. The output signal of the sensor is not normal.
3. The fastening screws at the parts that can be moved on the support frame are not fastened.
4. The height of the left and right supports is high and low, so that the rotor is tilted left and right or the plane of the journal is rubbed against the support.
5, the foundation of the installation balance machine does not meet the requirements, the bottom joint surface is not solid, the anchor bolts are not fastened, or placed on the floor, causing resonance.
6. The bearing block is seriously worn or the roller jumps.
7, there is dirt at the support, no lubrication.
8. The photoelectric head of the dynamic balancing machine is not aligned with the reflective paper, the mirror surface of the photoelectric head is blurred, and the position of the photoelectric head is skewed to cause angular deviation.
The above factors will affect the measurement of the balance machine. We should pay attention to the above factors when using the balance machine for dynamic balance measurement, in order to better obtain the experimental results and avoid the error!