Welcome to Guangzhou Zhuoxuanjin Machinert Equipment co.Ltd official website
Contact: Miss Li
Mobile phone: 18933956581
© 2018 Guangzhou Zhuoxuanjin Machinert Equipment co.Ltd | All rights reserved 粤ICP备14035600号
Professionally provides dynamic balance detection, correction and dynamic balance cleaning equipment for all types of high speed rotating workpieces (from 500 to 10,000 rpm)
Balancer measurement error is very large, teach you to effectively solve the balance machine error
Is the balance machine measurement error very good? what's the situation? Is the balance machine abolished?
With the time spent using the balancing machine, one year? Three years? Five years? Our balancing machine has gradually appeared some abnormalities, and it has even completely affected our work, or we have exceeded our knowledge of the level of understanding of the balancing machine. There may be no direct rotation after the speed and display speed change is too large. . Today, Xiaobian brings the common faults and solutions of dynamic balancing machines.
First, the cause of unstable balance speed
In fact, the reasons for the unstable speed measurement of the balance machine are:
1. The conveyor belt of the motor pulley is too loose
2, the sensor has no output signal
3, electrical measurement system components aging
4, the temperature production period exceeds the limit working temperature of the material
Second, what should I do if the display data is 0 or small?
First encounter the display data is 0 or very small, do not panic, this may not be a serious problem with the balance machine. When the data is 0 or very small, use the three-meter to measure. If the resistance is abnormal, it needs to be replaced or repaired.
1. If the balance machine only has one measurement value, it will not appear again in the future.
2. If the balancer appears at least once or more per day, the data is 0 or very small, then contact the balancer manufacturer for the problem.
Or contact us Guangzhou Zhuoxuanjin Machinery Equipment Co., Ltd.
3. If the data that appears is unstable and cannot work properly, you can try to re-calibrate the rotor first.
Third, the balance machine fault solution
1. It is possible that the rotor shaft of the motor is eccentric or curved, which causes the measurement error to be too large to accurately find the balance angle.
2. Check the bearing surface for dirt, which will cause the motor rotor to jump when it rotates.
3. Whether the fixed top bracket is locked and the support bracket is loose will cause the signal input of the balancer measurement system to be unstable.
4, the belt is too tight
5. The measured speed exceeds the dynamic balance parameter speed.
The above can solve the problem of the instability of the balance measurement data, and friends in need can try it.
The above is the analysis of the reasons for the instability of the balancer measurement value and common solutions. The next time you encounter data instability, you will not be in a hurry. Well, this issue will be shared here, and friends in need can Keep an eye on Xiaobian Get more tutorials on balancing machine installation and optimization.
If the above tutorial can't help you solve the problem, please contact our manual technical customer service solution, Guangzhou Zhuo Xuanjin Machinery Equipment Co., Ltd.