From the generation of the world's first balancing machine, to now, the balancing machine has passed several versions. Initially it was large in size, to the current miniature balancing machine, fully automatic balancing machine and so on. However, with the popularity of balancing machines, the use of balancing machines has become more frequent. If the balancer is used for a long time, it will be easy to heat up. If the heat is not good, it will affect the performance of the balancer and reduce the service life of the balancer. Nothing else will be repeated. The following is a brief introduction to the reasons and solutions for the underbalanced machine.

Dynamic balance test machine heat, high temperature has many reasons, usually below 70 degrees is normal, if it exceeds 90 degrees then it is a serious high temperature fever; we must first analyze the detection of dynamic balance test machine fever, in order to find a solution.

1. The power of the balancing machine is too small: in the process of selecting the dynamic balance testing machine, the power is selected relatively small compared to its load, thus causing the “small horse-drawn cart”, so the balancing machine works very hard, the natural load If it is too heavy, the balance machine will heat up and reduce the life of the balancer. Solution: Re-estimate the workload and switch to a high-power balancing machine.

2. Insufficient lubricating oil or improper use of lubricating oil: In the working process, if the lubricating oil is too small, the friction between the gears is increased, and the balancing machine rises due to excessive friction temperature; Properly, such as high-power balancing machines to choose better lubricants, and low-power balancing machines apply grease.

3. The working environment is not ventilated: the working environment of the balancing machine is not ventilated. It is also an important reason for the heat. The balancing machine is placed at a dead angle or covered by objects for a long time, so that the balancing machine can not normally dissipate heat and cause high temperature. Causes the balance machine to burn out. Solution: Do a good ventilation environment. If the temperature is too high, you can blow it with a fan to help cool down.

4. Assembly and quality problems: If the dynamic balance tester is not properly installed, there is an error, causing excessive friction and causing heat. Or the problem of balancing the quality of the machine itself, the parts are rough, and the amount of friction is increased.

In addition, the bearing balance of the dynamic balance tester is also one of the tests. The following is a brief description of the heat generation.
First, insufficient cooling, blocked water pipes or insufficient water pressure;
Second, the quality of the cooling water is not satisfactory, and there are many residues and impurities;
Third, the hot air entering the mill has a high temperature or does not stop the hot air;
Fourth, the insulated asbestos rope that protects the hollow shaft falls off;
Fifth, poor contact, improper installation.

In the above, we have a comprehensive introduction to the reasons for the heat of the balance machine and the related information. From the above we can roughly understand that the balance machine is too hot, mainly because of excessive overloading, or it may be caused by poor heat dissipation of the machine itself. Therefore, when using the balance machine on a daily basis, pay attention to maintenance. Otherwise it will reduce the service life, and if it is serious, it will burn out the accessories of the balance machine. So we need to master some tips, such as turning off the balancer power when not in use for a long time.