It is no longer a rare thing to see a dynamic balancing machine with intelligent dynamic balance measurement in a rotating workpiece (rotor) manufacturing factory. It is no exaggeration to say that most rotor manufacturing factories will use intelligent dynamic balancing in the next 2 to 3 years. Balancing machine. However, in the process of using the dynamic balancing machine, many people will have misunderstandings, improper use will affect the life of the dynamic balancing machine. The following is a brief introduction of Zhuoxuanjin, a well-known domestic balancing machine manufacturer, to introduce three misunderstandings that cannot be ignored in the process of using the balancing machine.



Myth 1: Ignore the quality of the product itself

Many rotor manufacturing industries think that every dynamic balancing machine produced is the same. Whoever buys it cheaply will buy it. This idea is very one-sided, because often the quality of cheap balancing machines is not only unsightly, but also prone to problems. This is not visible in the short term, but after one year of use, the gap gradually shows up, and some are of poor quality. The paint of the dynamic balancing machine is uneven, and it is easy to change color or fade after using for a period of time. In addition, inferior dynamic balancing machines have a high failure rate after a period of use, and sudden "strikes" occur from time to time. In this case, there is no need to toss.

Myth 2: No maintenance is needed for the maintenance of dynamic balancing machines

The body of the dynamic balancing machine is made of various metals, and it is easy to rust when contacting corrosive objects, so be careful not to use corrosive cleaning agents such as oil stains, keep the dynamic balancer clean and clean, and regularly clean dust, oil and other impurities. Thing. Since electrical components such as touch screen in the operation panel are easily damaged by moisture, please keep it dry.

Misunderstanding 3: Pursuing the upper limit of the speed of the dynamic balancing machine

Many friends in the manufacturing industry hope that the faster the measurement speed of the dynamic balancing machine, the better, so that the rotor's dynamic balance data can be measured more accurately, and the work efficiency is higher. In fact, this idea is undesirable. The reason is that the speed of the dynamic balancing machine is too fast, causing inertial objects to fall, which poses a greater safety hazard, and it is not that the higher the measurement speed, the more accurate the measurement of dynamic balance data. Therefore Zhuo Xuanjin recommends that when setting the dynamic balance machine to measure the speed, the speed should generally be set according to the manufacturer's standards.

The above three situations are the misunderstandings that many people are very easy to encounter when using the dynamic balancing machine. If you have other questions about the balancing machine? Welcome to contact Zhuo Xuanjin staff for consultation.