The vertical single-sided dynamic balancing machine only detects the imbalance (static imbalance) on one plane. Although it is tested when the rotor rotates, it should still be a static balance machine.
A balanced dynamic balancing machine is known as a balanced dynamic speed that is higher than the natural frequency of the rotor-support system. The dynamic balance of this type of dynamic balancing machine is small, and the signal measured by the sensor is proportional to the vibration displacement of the support. The balance speed is lower than the natural frequency of the rotor-support system. It is called a hard-support dynamic balancing machine. The dynamic balance of this type of dynamic balancing machine is large, and the signal measured by the sensor is proportional to the vibration force of the support.
The single-sided dynamic balancing machine has a permanent calibration test, and the precision of the equipment is very high, which can detect some workpieces with low precision.
The single-sided dynamic balancing machine has an excellent dynamic balance detection system, which is easy to operate.
The single-sided dynamic balancing machine has an idealized swing design, high reliability, low vibration, and good mechanical force.
The tooling fixtures equipped with the single-sided dynamic balancing machine can be used in a very wide range of applications, and the precision is also very high.
The single-sided dynamic balancing machine has a high-sensitivity sensor with high reliability, good durability and high sensitivity.

Vertical double-sided balancing machine can detect dynamic imbalance, and can also detect static imbalance and even imbalance, which is generally called dynamic balancing machine. Centrifugal force dynamic balancing machine can be divided into soft bearing dynamic balancing machine and hard bearing dynamic balancing machine according to different bearing characteristics. Dynamic balance correction is performed on one correction surface of the rotor, and the remaining unbalance amount after correction is used to ensure that the rotor is in the specified range of unbalance amount when static, called single-sided balance (static balance); and two correction surfaces on the rotor The dynamic balance correction is carried out, and the remaining unbalanced amount after correction is used to ensure that the rotor is within the allowable imbalance amount when it is dynamic, which is called a vertical double-sided dynamic balancing machine.
The double-sided dynamic balance maneuver balance workpiece not only can be balanced from one side, but also can be double-sided dynamic balance machine, which can convert each other and facilitate operation.
The double-sided dynamic balancing machine has excellent variable frequency motor drive, which is easy to operate and safe.
The double-sided dynamic balancing machine has high production efficiency and can be used for mass production of workpiece applications.
The above is a brief introduction and characteristic analysis of the single-sided dynamic balancing machine and the double-sided dynamic balancing machine. Both kinds of dynamic balancing machines have their own characteristics. No matter which type of dynamic balancing machine is applied, it is necessary to know what industry to apply to, and finally to pick Which type of balancing machine is right for you to avoid unnecessary losses.